As a bucket tooth manufacturer, we can produce various types of excavator bucket teeth.Ĭhoose bucket teeth with different hardness according to the construction environment. Purchase the corresponding bucket teeth according to the model of the excavator. The selection of bucket teeth needs to be judged according to the brand of excavation and the construction environment. I believe you will become more and more proficient after doing it a few times. The disassembly and assembly of the bucket teeth is not difficult, and the bucket teeth of the excavator can be replaced with simple tools. Lock the groove of the pin with the retainer. Insert the pin from the other side of the retainer and strike with a hammer. And keep the bucket teeth from falling off.Ĥ. If there is, it needs to be cleaned up.ģ. Adjust the bucket to a suitable position and fix it.Ģ. If the shank is severely worn, it also needs to be replaced together. Once the pins are removed, the old bucket teeth can be easily removed from the adapter.Īfter removing the bucket teeth, check the tooth handle. Then use a wire brush to remove the dirt around the bucket teeth.įinally, use the Bucket Tooth Pin Removal Tool with a hammer to push out the bucket tooth pin. Hold the bucket teeth parallel to the ground and support with stakes/jacks to stabilize the bucket. Bucket tooth removalīegin by adjusting the adjustment bucket to a position where it can be easily maneuvered. If the construction conditions are more complicated, it is also necessary to prepare to put a “maintenance, prohibited operation” sign on the operating table. There are other preparations to do before the bucket teeth are removed. The finger pin shaft of the horizontally mounted bucket tooth is installed parallel to the front of the excavating bucket tooth. The finger pin shaft of the direct-mounted bucket tooth is installed vertically with the front face of the excavating bucket tooth. How to remove bucket teeth?īefore disassembling the bucket teeth, let’s first understand the structure of the next two bucket teeth. For example, it is recommended to use rock chisel bucket teeth for digging rocks. It is recommended to replace the appropriate excavator teeth according to the excavator construction environment. If necessary, change the construction environment. If it is used to excavate loose ground such as sand, the frequency of inspection and replacement can be reduced.Ģ. If the excavator is used to excavate hard stones such as rocks, it should be checked and replaced frequently. Regularly check whether there is serious wear and tear according to the working environment of the excavator. When it is necessary to replace the excavator teeth, please refer to the following 2 points.ġ. This article will introduce how to replace bucket teeth. Also don’t know how to replace the bucket teeth. Many excavator operators do not know when to replace bucket teeth. Bucket teeth are the most easily worn parts on an excavator. Good excavator bucket teeth can improve the working efficiency of the excavator and reduce the pressure on the boom and arm.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |